Ok,lets start… Open your file that your going to edit… This one will be in the description. Make a new layer and fill it with black. Then go to render>lends flare and copy my settings. Make the layer hard light. Then move your light ball to your designation. Add a layer mask to it. Set your colours to white and black Then go to gradiant map and make sure its radial. Then drag from the middle out. Duplicate the layer. Merge the 2 layers. Then goto image>adjustments>photo filter. Select your colour and play around with the density. Copy your colour code cause you’ll need it after. Make a new layer. Select the brushes [ download in des. ] Paint on your designs to your balls lol. Fancy it up how ever you wish 🙂 Add an outer glow to your brushes folder. Use your colour code copied before. Make a new layer. Grab your pen tool and make a nice curve. Make sure you have a nice soft edged brush around this size. Use your direct selection tool. Select the 2 points. Then right click and select stroke path. Make sure its on brush and simulate brush pressure. Make your new line the same colour code copied. Select this brush and paint along your line. If you make more than 1 layer, merge them together. You an give them a little clean up with the eraser. Add an outer glow. Once again, use your copied colour code. Play around till you get your effect nice. Then save as a jpeg and your good to go=] Thanks for watching and please comment,rate n subscribe. Thanks for watching and please comment,rate n subscribe.